Charger for use with our 12V Slim Battery. The output is wired with an XT30 male connector for charging. For the input, the battery charger has an IEC C13 power cord to standard, grounded, North America wall outlet plug (NEMA 5-15).
*Do not plug the Battery Charger directly into a Control Hub or an Expansion Hub, this will damage the Hub and void the warranty.
Battery Charger
מק"ט: REV-31-1299
208.00 ₪מחיר
כולל מע״מ
All rechargeable batteries have a finite lifespan. Factors that affect lifespan include the number of discharge/charge cycles and the average loading of the battery. The following best practices can help maximize the lifespan of your battery:
- Charge Rate
- Minimum: 1.5A
- Maximum: 3.0A
- Recommended: 1.8A or 2.0A
- Do Not Overcharge
- Disconnect the battery from the charger once it indicates a full charge
- Typical charge time does not exceed 2 hours
- Do not charge a battery that hasn't been discharged significantly
- For example, running the robot under minimal load for a few minutes will not significantly discharge the battery
- Minimum No-Load Voltage: 9.0V
- Discharging the battery past 9.0V can reduce the lifespan of the battery and can permanently damage the cells
- Periodic dips below 9.0V when under load is expected and OK
- For example, don't forget to unplug your battery after you are finished running the robot and don't run your robot until it completely stops responding
- Temperature
- Let the battery cool before and after charging
- The battery may feel warm after heavy loading or after charging, this is normal
- Charge Rate
- Input Voltage: 100-240VAC
- Input Frequency: 50/60Hz